Aaeon AGD-310D Bedienungsanleitung

LCD Display AGD-310D AGD-310D 10.4” SVGA Rugged Touch Display On Screen Display Control IP-65 Front Be

LCD Display AGD-310D Chapter 1 General Information 1-1 General Chapter 1Information

LCD Display AGD-310D Chapter 1 General Information 1-2 1.1 Introduction Thank you for purchasing of the Industry Display Panel TFT LCD monitor - a m

LCD Display AGD-310D Chapter 1 General Information 1-3 1.2 Features  10.4” SVGA (800 x 600) TFT LCD Display  Wide Temper

LCD Display AGD-310D Chapter 1 General Information 1-4 1.3 General Specification  Type Color TFT  Size 10.4" TFT LCD  Construction IP-65

LCD Display AGD-310D Chapter 1 General Information 1-5 Touchscreen  Type 5-wire resistive  Resolution 2048 x 2048  Lig

LCD Display AGD-310D Chapter 1 General Information 1-6 1.4 Dimension AGD- 310DCUT OUT:231*198mmUntis:m m309.00216.0049.0010.4076.20205.606.00288.207

LCD Display AGD-310D Chapter 2 Hardware Installation 2-1 Hardware Chapter 2Installation

LCD Display AGD-310D Chapter 2 Hardware Installation 2-2 2.1 Before Unpacking It is very important to place the LCD Display in a suitable environmen

LCD Display AGD-310D Chapter 2 Hardware Installation 2-3 2.2 Connecting Power To power up the LCD Display, use the provided

LCD Display AGD-310D Chapter 2 Hardware Installation 2-4 2.3 Connecting to the Computer Turn off the computer and the LCD Display before connecting.

LCD Display AGD-310D i Copyright Notice This document is copyrighted, 2011. All rights are reserved. The original manufacturer reserves the ri

LCD Display AGD-310D Chapter 2 Hardware Installation 2-5 2.4 VGA Port Connector This DB-15 connector can be connected to the

LCD Display AGD-310D Chapter 2 Hardware Installation 2-6 2.5 DVI Port Connector Connecting a standard DVI-D connector through I/O port of this unit.

LCD Display AGD-310D Chapter 2 Hardware Installation 2-7 2.6 Serial Port Connector For Touch Screen This pin definition of t

LCD Display AGD-310D Chapter 2 Hardware Installation 2-8 2.7 USB Type A Connector For Touch Screen This pin definition of the connector will be refe

LCD Display AGD-310D Chapter 2 Hardware Installation 2-9 2.8 Panel Mounting This LCD Display can be placed on a shelf or tab

LCD Display AGD-310D Chapter 2 Hardware Installation 2-10 2.9 VESA Wall Mounting Mounting the LCD Display with UL Listed Wallmount Bracket only. The

LCD Display AGD-310D Chapter 2 Hardware Installation 2-11 VESA Mounting Holes To mount the LCD Display onto a monitor arm or

LCD Display AGD-310D Chapter 3 On Screen Display Control 3-1 On Screen Chapter 3Display Control

LCD Display AGD-310D 3.1 On Screen Display (OSD) Board Description Buttons Description Power  Turn the monitor power ON or OFF.Menu / Enter  A

LCD Display AGD-310D 3.2 OSD Main Menu: Push The MENU Keys Available Key Functions Power On/Off the LCD Monitor Return to last menu Selected to

LCD Display AGD-310D ii Acknowledgments  Intel® is registered trademarks of Intel® Corporation.  IBM, PC/AT, PS/2 are trademarks of Interna

LCD Display AGD-310D 3.3 Select Input Source • Available Key Functions Power On/Off the LCD Monitor Return to last menu Selected to confirm I

LCD Display AGD-310D 3.4 Contrast/ Brightness- Submenu Available Key Functions Power On/Off the LCD Monitor Return to last menu Selected to con

LCD Display AGD-310D 3.5 Geometry Menu Available Key Functions Power On/Off the LCD Monitor Return to last menu Selected to confirm Increase t

LCD Display AGD-310D 3.6 Color Temperature- Submenu Available Key Functions Power On/Off the LCD Monitor Return to last menu Selected to confir

LCD Display AGD-310D 3.7 RGB Color- Submenu Available Key Functions Power On/Off the LCD Monitor Return to last menu Selected to confirm Inc

LCD Display AGD-310D 3.8 Language- Submenu Available Key Functions Power On/Off the LCD Monitor Return to last menu Selected to confirm Incr

LCD Display AGD-310D 3.9 Auto Config- Submenu Available Key Functions Power On/Off the LCD Monitor Return to last menu Selected to confirm I

LCD Display AGD-310D 3.10 Mode Resolution- Submenu Available Key Functions Power On/Off the LCD Monitor Return to last menu Selected to confi

LCD Display AGD-310D Chapter 3 On Screen Display Control 3-12 3.11 Exit Menu- Submenu Available Key Functions Power On/Off the LCD Monitor

LCD Display AGD-310D Chapter 4 Touch Screen Driver Installation 4-1 Touch Screen Chapter 4Driver Installation

LCD Display AGD-310D iii Packing List The LCD monitor comes with the following standard parts shown as below. Check and make sure they are incl

LCD Display AGD-310D 4.1 Introduction The optional AGD-310D Series touch screen uses 5-wire resistive technology to provide more accurate sensing

LCD Display AGD-310D Serial Interface • EIA 232E (Serial RS-232), DCE configuration. 8 Data Bits, 1 Stop Bit, No Parity, Full Duplex. • Hardware

LCD Display AGD-310D Operating Modes Full Touch Smart Set protocol. Emulation of E281A-4002 protocol can be selected by Smart Set command. Initial/

LCD Display AGD-310D 4.2 Resistive Touchscreen Driver Installation Hardware Touch screen controllers must be configured for the driver prior to in

LCD Display AGD-310D HID drivers that provide low-level support for EETI touch screen controller. An EETI touch monitor with a USB touch screen cont

LCD Display AGD-310D 4.3 Installing Driver for Windows® XP/ Windows® 7 / Linux The touch screen has drivers for Windows® XP、 Windows® 7 and Linux

LCD Display AGD-310D 2. Click the “Next” button on the screen 3. Click on the “Finish” button and restart your system Single monitor, Serial Port

LCD Display AGD-310D 1. Executing eGalax on Desktop 2. Recognition devices choose to run calibration immediately Chapter 4 Driver Install

LCD Display AGD-310D 3. Choose Tools to calibrate 4. Click on 4 Points Calibration to execute calibration Note: If the alignments do not match d

LCD Display AGD-310D For Windows® 7 OS please execute: CD-ROM: \\TouchScreen-DRV\eGalax Touch \Win 7 \Setup.exe 1. Click on the “Next” button 2.

LCD Display AGD-310D iv Safety & Warranty 1. Read these safety instructions carefully. 2. Keep this user's manual for later re

LCD Display AGD-310D 3. Tick “None” if the system did not start 4 points calibrating after reboot. Click on the “Next” button. 4. Tick “Support Mu

LCD Display AGD-310D 5. Select Destination Folder, and click on the “Next” button 6. Click on the “Next” button Single monitor, Serial Port co

LCD Display AGD-310D 1. Executing eGalax on Desktop 2. Recognition devices choose to run calibration immediately Chapter 4 Touch Screen D

LCD Display AGD-310D 3. Choose Tools to run calibration 4. Click on 4 Points Calibration to execute calibration Note: If the alignments do not ma

LCD Display AGD-310D For Linux Fedora 14 kernel 2.6.35.6-45.fc14 OS please execute: CD-ROM: \\TouchScreen-DRV\eGalax Touch \Linux\eGalaxTouch 32

LCD Display AGD-310D 3. Input command ( cp /root/xorg.conf.new /etc/X11/xorg.conf) 4. Load Linux Folder Touch Driver Chapter 4 Driver Install

LCD Display AGD-310D 5. Executive Touch Driver 6. Which interface controller do you use? Chapter 4 Touch Screen Driver Installation 4-18

LCD Display AGD-310D 7. Select the “ 3 ” USB interface. (Select the USB interface and press “Enter” key of the keyboard to start the installation

LCD Display AGD-310D 9. Execute reboot 10. Select the X86 Folder (Because Linux is 32 bit) Chapter 4 Touch Screen Driver Installation 4-20

LCD Display AGD-310D 11. Select “eGalax Touch32_Version1.1-2.6X” Folder 12. Select “eGalax Touch32” Folder Chapter 4 Driver Installation 4-21

LCD Display AGD-310D v 14. If any of the following situations arises, get the equipment checked by service personnel: a. The power cord or p

LCD Display AGD-310D 13. Click on the “eGalax Touch” to calibrate immediately 14. Choose “Tool” to calibrate Chapter 4 Touch Screen Driv

LCD Display AGD-310D 15. Execute 4 Points Calibration Note: If the alignments do not match display by 4 Points Calibration, please use 9 Ports

LCD Display AGD-310D Chapter 4 Touch Screen Driver Installation 4-24 17. If you are going to replace the Interface, please remove the old Touch D

LCD Display AGD-310D vi Below Table for China RoHS Requirements 产品中有毒有害物质或元素名称及含量 AAEON Display 有毒有害物质或元素 部件名称 铅 (Pb)汞 (Hg)镉 (Cd)六价铬(Cr(VI))多溴联

LCD Display AGD-310D vii Contents Chapter 1 General Information 1.1 Introduction.....

LCD Display AGD-310D viii 3.6 Color Temperature- Submenu OSD Main Menu: Push The MENU Keys..............