Aaeon AEC-6643 Bedienungsanleitung

Embedded Controller AEC-6643 AEC-6643 Fanless Embedded Controller Intel® NM10 Chipset 2 Gigabit Ethernet 6 USB2.0, 4 COM 1 Mini Card 1 VGA, 1 D

Embedded Controller AEC-6643 Chapter 1 General Information 1- 1 Chapter General 1Information

Embedded Controller AEC-6643 Chapter 1 General Information 1- 2 1.1 Introduction The newest Boxer series AEC-6643 has been introduced by AAEON and i

Embedded Controller AEC-6643 Chapter 1 General Information 1- 3 1.2 Features z Intel® Atom™ D2550 B3 Processor z Intel® NM10 Chipset (PCH) z CO

Embedded Controller AEC-6643 Chapter 1 General Information 1- 4 1.3 Specifications CPU Intel® Atom D2550 B3 Processor Chipset Intel® NM10 System M

Embedded Controller AEC-6643 Chapter 1 General Information 1- 5 Power Requirement Lockable DC jack x 1 for DC12V System Cooling Passive Mounting W

Embedded Controller AEC-6643 Chapter 2 Hardware Installation 2-1 Chapter Hardware Installation 2

Embedded Controller AEC-6643 Chapter 2 Hardware Installation 2 - 2 2.1 Dimension & Connectors of AEC-6643

Embedded Controller AEC-6643 Chapter 2 Hardware Installation 2 - 3Connectors on the front panel Connectors on the rear panel

Embedded Controller AEC-6643 Chapter 2 Hardware Installation 2 - 4 2.2 Connectors and Jumpers of The Main Board Component Side

Embedded Controller AEC-6643 Solder Side Chapter 2 Hardware Installation 2 - 5

Embedded Controller AEC-6643 i Copyright Notice This document is copyrighted, 2013. All rights are reserved. The original manufacturer reserv

Embedded Controller AEC-6643 Chapter 2 Hardware Installation 2 - 6 2.3 List of Jumpers The board has a number of jumpers that allow you to config

Embedded Controller AEC-6643 Chapter 2 Hardware Installation 2 - 7CPU_FAN CPU FAN Connector DIGITALREFENCEGPIO/SM BUS/COM2/ COM2 External Power Sel

Embedded Controller AEC-6643 Chapter 2 Hardware Installation 2 - 8 2.5 Setting Jumpers You configure your card to match the needs of your applicati

Embedded Controller AEC-6643 Chapter 2 Hardware Installation 2 - 92.6 AT/ATX Mode Selection (ATMODE) ATOMODE Function Close 1-2 AT Close 2-3 ATX

Embedded Controller AEC-6643 Chapter 2 Hardware Installation 2 - 10 9 RI 2.11 Serial ATA Power Connector (SATA_PWR1) Pin Signal Pin Signal 1 +

Embedded Controller AEC-6643 Chapter 2 Hardware Installation 2 - 112.12 Hard Disk Drive (HDD) Installation Step 1: Unfasten the four screws of the A

Embedded Controller AEC-6643 Chapter 2 Hardware Installation 2 - 12 Step 4: Fasten the four screws to install the HDD and HDD Bracket to the chasis

Embedded Controller AEC-6643 Chapter 2 Hardware Installation 2 - 132.13 Memory Card Installation Step 1: Unfasten the four screws of the AEC-6643. S

Embedded Controller AEC-6643 Chapter 2 Hardware Installation 2 - 14 2.14 Wallmount Kit Installation Get the brackets ready and fasten appropriate f

Embedded Controller AEC-6643 Chapter 3 AMI BIOS Setup 3-1 Chapter AMI 3BIOS Setup

Embedded Controller AEC-6643 ii Acknowledgments All other products’ name or trademarks are properties of their respective owners. • AMI is a t

Embedded Controller AEC-6643 3.1 System Test and Initialization These routines test and initialize board hardware. If the routines encounter an err

Embedded Controller AEC-6643 backup for data retention. You have to replace the battery when it finally runs down. 3.2 AMI BIOS Setup AMI BIOS ROM

Embedded Controller AEC-6643 Setup Menu Setup submenu: Main Chapter 3 AMI BIOS Setup 3-4

Embedded Controller AEC-6643 Security Chapter 3 AMI BIOS Setup 3-5

Embedded Controller AEC-6643 Change User/Supervisor Password You can install a Supervisor password, and if you install a supervisor password, you ca

Embedded Controller AEC-6643 Setup submenu: Advanced Chapter 3 AMI BIOS Setup 3-7

Embedded Controller AEC-6643 ACPI Settings Options summary : Disabled Default Show Turn Off String Enabled Enable or disable ‘It is now safe to tu

Embedded Controller AEC-6643 CPU Configuration Options summary : Disabled Hyper-Threading Enabled Optimal Default, Failsafe Default En/Disable CP

Embedded Controller AEC-6643 System Agent Configuration Options summary : Auto Initiate Graphic Adapter Enabled Optimal Default, Failsafe Default

Embedded Controller AEC-6643 Intel IGD Configuration Options summary : VBIOS Default Optimal Default, Failsafe Default CRT IGFX – Boot Type DVI

Embedded Controller AEC-6643 iii Packing List Before you begin operating the product, please make sure that the following materials are enclo

Embedded Controller AEC-6643 PCH Configuration Options summary : Disabled High Precision Timer Enabled Optimal Default, Failsafe Default Enabled/

Embedded Controller AEC-6643 SATA Configuration Options summary : Disabled SATA Controllers Enabled Default SATA Ports (0-1) Device Names if Prese

Embedded Controller AEC-6643 USB Configuration Options summary : Enabled Optimal Default, Failsafe Default Legacy USB Support Auto Enables Le

Embedded Controller AEC-6643 Onboard Devices Configuration Options summary : Enabled Optimal Default, Failsafe Default HD Audio Controller Disabl

Embedded Controller AEC-6643 Enabled Optimal Default, Failsafe Default Serial Port 4 Disabled Enable or Disable Serial Port Chapter 3 AMI BIOS Se

Embedded Controller AEC-6643 APM Options summary : Power Off Optimal Default, Failsafe Default Power On Restore AC Power Loss Last State Speci

Embedded Controller AEC-6643 Monitor Chapter 3 AMI BIOS Setup 3-18

Embedded Controller AEC-6643 Boot Options summary : On Optimal Default, Failsafe Default Bootup NumLock State Off Select the key board NumLock st

Embedded Controller AEC-6643 BBS Priorities Chapter 3 AMI BIOS Setup 3-20

Embedded Controller AEC-6643 Setup submenu: Exit Chapter 3 AMI BIOS Setup 3-21

Embedded Controller AEC-6643 iv Safety & Warranty 1. Read these safety instructions carefully. 2. Keep this user's manual for later

Embedded Controller AEC-6643 Chapter 4 Driver Installation 4 -1 Chapter Driver 4Installation .

Embedded Controller AEC-6643 The AEC-6643 comes with an AutoRun DVD-ROM that contains all drivers and utilities that can help you to install the dri

Embedded Controller AEC-6643 4.1 Installation: Insert the AEC-6643 DVD-ROM into the DVD-ROM drive. And install the drivers from Step 1 to Step 8 in

Embedded Controller AEC-6643 Step 3 –Install LAN Driver (Realtek Chip) 1. Click on the STEP3-LAN folder and select the OS folder your system is

Embedded Controller AEC-6643 Appendix A Programming the Watchdog Timer A-1 Programming the Appendix AWatchdog Timer

Embedded Controller AEC-6643 Appendix A Programming the Watchdog Timer A-2 A.1 Watchdog Timer Initial Program Table1:SuperIOrelativeregister

Embedded Controller AEC-6643 Appendix A Programming the Watchdog Timer A-3 ****************************************************************

Embedded Controller AEC-6643 Appendix A Programming the Watchdog Timer A-4 **********************************************************************

Embedded Controller AEC-6643 Appendix A Programming the Watchdog Timer A-5 ****************************************************************

Embedded Controller AEC-6643 Appendix A Programming the Watchdog Timer A-6 **********************************************************************

Embedded Controller AEC-6643 v d. The equipment does not work well, or you cannot get it to work according to the user’s manual. e. The

Embedded Controller AEC-6643 Appendix A Programming the Watchdog Timer A-7 ****************************************************************

Embedded Controller AEC-6643 Appendix B I/O Information B-1 I/O Information Appendix B

Embedded Controller AEC-6643 Appendix B I/O Information B-2 B.1 I/O Address Map

Embedded Controller AEC-6643 Appendix B I/O Information B-3

Embedded Controller AEC-6643 Appendix B I/O Information B-4 B.2 Memory Address Map

Embedded Controller AEC-6643 Appendix B I/O Information B-5 B.3 IRQ Mapping Chart

Embedded Controller AEC-6643 Appendix B I/O Information B-6

Embedded Controller AEC-6643 Appendix B I/O Information B-7

Embedded Controller AEC-6643 Appendix B I/O Information B-8 B.4 DMA Channel Assignments

Embedded Controller AEC-6643 Appendix C AHCI Settings C-1 AHCI Settings A ppendixC

Embedded Controller AEC-6643 vi Below Table for China RoHS Requirements 产品中有毒有害物质或元素名称及含量 AAEON Boxer/ Industrial System 有毒有害物质或元素 部件名称 铅 (

Embedded Controller AEC-6643 Appendix C AHCI Settings C-2 C.1 Setting AHCI OS installation to SETUP AHCI Mode Step 1: Copy below files from “Driver

Embedded Controller AEC-6643 Appendix C AHCI Settings C-3 Step 4: Configure DVD/CD-ROM drive as the first boot

Embedded Controller AEC-6643 Appendix C AHCI Settings C-4 Step 6 – Boot to DVD/CD-ROM device to install OS Step 7 – Press “F6” to install AHCI driv

Embedded Controller AEC-6643 Appendix C AHCI Settings C-5 Step 9 – Choose “Intel(R) NM10 Express Chipset”. St

Embedded Controller AEC-6643 vii Contents Chapter 1 General Information 1.1 Introduction.....

Embedded Controller AEC-6643 viii 3.2 AMI BIOS Setup..............3-3 Chapter 4 Driver Installation